Dongguan Botai Electronics Co., Ltd.
Tel: 0769-8263 6114
Fax: 0769-8263 6114
Contact : Mr. Zhuang
Tel : 18681169907
18681144438
QQ:422376265 695316608
E-mail : : ericlszhuang@163.com
Address: 2 floor, north of yellow river, No. 3 Xiangye street, Liaobu Town, Dongguan City.
Jiangsu branch
Mr. Zhuang: 15850304699
Mr. Xiong: 13616288556
Address: room 1301, block A, New World Plaza, Jianwei, Kunshan, Jiangsu.
Website: quickie-burger.com
When soldering tin, the voltage of the automatic soldering machine should be reduced by 5% compared with the original voltage.
Three problems that should be paid attention to during the operation of automatic soldering machine
1, solder joints
In the operation process of the automatic soldering machine, the solder joints should not be too full, because the simple formation and the surrounding solder joints are disconnected from each other, but it can not be too economical, and the phenomenon of virtual soldering is simply presented. The best application of the automatic soldering machine is the center position of three or four points. This solder joint is not full or tin-saving. The best contact between the solder joint and the component can also be determined. The board is well defined.
2, the iron mouth
In the process of using the automatic soldering machine, the soldering iron nozzle does not need to be cleaned by the sponge. Just put the tin on the soldering iron mouth in the tin-collecting carton, so that the temperature of the soldering iron mouth can be maintained. If you don't use the soldering iron at all times, after cleaning with a sponge, you must leave a certain tin on the soldering iron tip, instead of cleaning it directly on the soldering iron frame, compared to the next time you use the soldering iron nozzle, the need to clean again. .
3, voltage
When using an automated soldering machine, the voltage should be 5% less than the original voltage, and the original voltage should not exceed 10% of the power supply voltage. If the voltage is too low, it will simply lead to the phenomenon that the AC contactor is not properly connected. This time will also involve the problem of the power supply. It is necessary to deal with the power supply problem before it can be used normally.
Scan QR code
 | Service Hotline：18681169907 18681144438 |
 | QQ ：695316608 |
 | ADD：2nd Floor, North of Huangsha River, No. 3, Xinye Street, Xiangxi Village, Liaobu Town, Dongguan City |
Website:quickie-burger.com
Online consultation
